Bay Technical Associates BayStack Fiber Media Adapter - Manual (Page 7)

893-863-A 5
Redundant Enable Jumper
Jumper JP1 is used to set the port to operate in the redundant port
mode. The 10BASE-FL RDN Media Adapter is shipped with the
redundant port mode set to off.
To set the port to operate in the redundant port mode, perform the
following steps:
• Locate the shunt covering the JP1 jumper pins on the media
adapter board.
• Gently remove the shunt from the two far left pins.
• Replace the shunt over the two far right pins.
NOTE: Jumpers JP2, JP3, and JP4 are not
user-configurable.
Jumper 1
RDN EN
JP1 JP1
RDN EN
Default
mode
Redundant
mode
6771