AEG BHT 5640 - Manual (Page 28)

English
28
CAUTION:
After 12 hours always disconnect from mains power supply.
Note lifefime rechargeable battery
You can extent the lifetime of the rechargeable battery by
following these steps:
• Only charge after the battery is nearly exhausted.
• Do not charge for more than 12 hours.
• Charge the unit at temperatures between 0° and
+ 40°C.
Usage
Switching on and off
Slide the button (11) to turn the device on or off.
Putting on and taking off the attachments
WARNING:
Always switch the device off before you fit attachments or
accessories!
• Push an attachment onto the device. You must hear it
click into place.
• In order to release the attachment from the device, press
the button (12) and pull the attachment off.
• Push a comb attachment onto the mounted attachment.
It must click into place at the side.
• Comb attachment (3) to hair trimmer attachment (14)
• Comb attachment (4) to beard trimmer attachment (8)
• In order to remove the comb attachment (3) from the
trimmer, push the comb attachment backwards at the
locking catches (13).
• In order to remove the comb attachment (4) from the
trimmer, use your thumb to press the comb attachment
upwards at the
▲symbol. Use your other hand to hold the
comb attachment.
Cut hair and beard
1. Attach the hair trimmer attachment (14) or the beard trim-
mer attachment (8) to the device.
2. Attach the respective comb attachment (3 or 4) to the
trimmer.
3. In order to adjust the desired cutting length, press and
slide the button on the comb attachment at the same
time. The length setting is shown on the right hand side
next to the button.
4. Switch the device on.
5. Begin with the longest cutting setting and cut your hair in
stages to the desired length.
Length setting
Cutting length in mm (approx.)
Hair trimmer
Beard trimmer
1 = 11 2.5
2 = 12 3.0
3 = 13 3.5
4 = 14 4.0
5 = 15 4.5
6 = 16 -
7 = 17 -
8 = 18 -
9 = 19 -
10 = 20 -
NOTE:
The cutting lengths can vary, depending on the cutting
technique.
6. Switch the device off before you remove the comb at-
tachment from the trimmer.
Outlining and Shaving the Neck
• Use the beard trimmer without a comb attachment.
• The clipper head allows precise outlining the shape of
the beard, even in difficult to reach places as well as a
clean shaving of the hair-line at the neck.
Using the shaver attachment
The shaver attachment has been specifically designed for
close shaving on the beard, moustache and sideburns.
1. Attach the shaver attachment (7) to the device.
2. Switch the device on.
3. Hold the device in such a way that the shaver attachment
makes light contact with the face at a 45 degree angle.
Removing nasal hair / ear hair
WARNING: Risk of injury!
• Only remove hair protruding from the nostril / ear lobe.
• Never push the device into the nostril / ear lobe using
force.
• Never insert the device into the nostril / ear lobe further
than the narrow tip of the shaver head.
1. Attach the nasal hair / ear hair trimmer (6) to the device.
2. Switch the device on.
3. Carefully insert the tip of the shaver head into the nostril
or ear lobe and remove it again.
Finish Operation
Turn the device off. The “OFF” display of the switch appears.