AEG EZ 5623 - Manual (Page 23)

English
23
• Cleaning and user maintenance must not be carried out by
children, unless they are supervised.
• Store the device out of the reach of children. Children may not
play with the device.
• In order to ensure your children’s safety, please keep all packag-
ing (plastic bags, boxes, polystyrene etc.) out of their reach.
WARNING!
Caution! Do not allow small children to play with the foil as
there is a
danger of suffocation!
2. Connect the appliance to a properly installed isolated
ground receptacle.
Charging the battery
Charge the built-in battery prior to first use of the toothbrush.
1. Press the “
O” button once to make sure the device is
switched off.
2. Put the toothbrush onto the charger.
3. Connect the mains plug to the wall socket.
NOTE:
• The indicator lamp lights up indicating the connection
with the docking station.
• The indicator lamp does not provide any information
on the charging status of the battery.
• Charging the appliance for the first time will take ap-
prox. 14 hours.
• Put the toothbrush onto the docking station after use.
That way it will be ready for use even when used several
times a day.
CAUTION:
• The maximum charging time is 48 hours. Overcharging
will affect the battery’s lifetime.
• During longer periods of absence or non-use, discon-
nect the mains plug of the docking station from the wall
socket.
Usage
1. Stick the brush attachment onto the device. The brush
head will show in the direction of the | / O switch. If nec-
essary, remove the protective foil.
2. Moisten the brush head and apply some toothpaste.
3. Rinse your mouth with water.
4. Guide the brush to your teeth before turning on the
device with the | switch. You will thus prevent splatters.
Scope of delivery
1 docking station
1 toothbrush with built-in battery
4 brush heads
Installation material:
1 wall bracket
2 dowels
2 screws
Operating instructions
Wall mounting
It is recommended to wall-mount the docking station for safe
operation.
First attach the wall bracket to the wall, and then slide the
docking station onto the wall bracket.
NOTE:
A wall socket must be in near proximity.
CAUTION:
Make sure there is no wiring or water pipes at the location
where the wall bracket is to be mounted.
1. Measure the distance between the two holes in the wall
bracket. Then drill two holes with the same distance into
the wall.
2. Plug the dowels into the wall.
3. Secure the bracket with the screws.
4. Slide the charger from above onto the wall bracket until it
locks into place.
Mains connection
1. Before connecting the mains plug to the wall socket,
make sure the mains voltage to be used matches the
voltage requirements of the appliance as indicated on
the rating plate of the docking station.