AEG BSS 4804 - Manual (Page 33)

English
33
1. Press the MODE button (2/1) repeatedly until the indica-
tor light (5) illuminate pink.
2. Connect a USB storage device directly into the port.
Playback then begins.
For operation, please refer to the section “Description of the
controls”.
NOTE:
• Always directly connect a USB storage medium to the
USB port to prevent any malfunctions.
• The USB port is not designed for charging external
devices.
• The 5 V USB voltage is also activated in standby.
CAUTION:
Before removing the USB storage device, switch the device
to another mode using the MODE button (2/1).
Description of the controls
(1/2)
You can pause and continue music playback. Press again to
continue playback.
NOTE:
The activated function cannot be displayed for technical
reasons.
(5/4)
Press 1 x = Will re-start the current song from the begin-
ning. (Only in Bluetooth mode)
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previous song.
(5/4)
Press to skip to the next song and the following songs.
RPT (3) (only in USB mode)
Activates the Repeat function.
• Press the button to repeat only the current title. The
indicator light (5) flashes quickly.
RAN (8) (only in USB mode)
Activates random playback. All titles are played back in a
random sequence. To deactivate the function again, press
the RPT button 2x.
NOTE:
The activated function cannot be displayed for technical
reasons.
/ (7) (only in USB mode)
If folders exist, the next or previous folder is selected. The
playback is stopped. Press the OK button (4), to start the
playback in the selected folder.
OK (4) (only in USB mode)
Playback starts in the previously selected folder.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause Solution
Unit cannot be
operated. Unit crashes
and “hangs”. Disconnect from the
mains for around
5 seconds. Then switch
the unit on again.
No audio signal
via the Bluetooth
connection Speaker is not
paired to the
audio source. Check whether a connec-
tion exists. If necessary,
pair the speaker again to
the audio source.
Volume too
low Increase the volume on
the speaker
Increase the volume on
the audio source.
Speaker cannot
be connected Pairing does
not work Check whether the audio
source supports the
A2DP protocol.
Audio source
is switched off Switch on the audio
source
Bluetooth is
switched off
at the audio
source. Switch on the Bluetooth
function in the audio
source.
Bluetooth
version is not
supported. Use a different playback
unit.
Music tracks are
played back via
USB in the wrong
sequence. Random
playback is
activated. Press the RPT button 2x
(3).