AEG A52010GNW0 - Manual (Page 32)

A
B
• Unscrew the pin (A) and screw it on
the opposite side.
• Remove the cap (B) and position it on
the opposite side.
• Screw the lower hinges.
• Refit the plinth.
• Stand the appliance upright.
• Fit the handle on the opposite side
and put the plastic caps (contained in
the instructions bag) in the free holes.
• Do a final check to make sure that:
– All screws are tightened.
– The door opens and closes correct-
ly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
9. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
32 www.aeg.com