AEG HG755521UM - Manual (Page 11)

MOD.
PROD.NO.
SER.NO
DATA MOD.
PROD.NO.
SER.NO
DATA
MODEL MODEL
MOD.
PROD.NO.
SER.NO.
03 IT
MADE IN ITALY
TYPE
230V-50Hz
IP20 0049
A B C
A) Stick it on Guarantee Card and send
this part (if applicable)
B) Stick it on Guarantee Card and keep
this part (if applicable)
C) Stick it on instruction booklet
8. INSTALLATION
WARNING!
Refer to the Safety chapters.
WARNING!
The following instructions about
installation, maintenance and
ventilation must be carried out
by qualified personnel in compli-
ance with the regulation in force
(UNI-CIG 7129 - 7131). Make sure
that the kitchen is well ventilated:
keep natural ventilation holes
open (at least 100 cm²) or install a
mechanical extractor hood.
8.1 Gas Connection
Choose fixed connections or use a flexi-
ble pipe in stainless steel in compliance
with the regulation in force. If you use
flexible metallic pipes, be careful they
do not come in touch with mobile parts
or they are not squeezed. Also be care-
ful when the hob is put together with an
oven.
Make sure that the gas supply
pressure of the appliance obeys
the recommended values.
If the supplied pressure has not the
specified value, it is necessary to assem-
ble a proper pressure regulator in com-
pliance with the standard UNI EN 88. For
Liquid Gas (LPG) the use of pressure
regulator is allowed only if they are in
compliance with UNI EN 12864. The ad-
justable connection is fixed to the com-
prehensive ramp by means of a threa-
ded nut G 1/2". Screw the parts without
force, adjust the connection in the nec-
essary direction and tighten everything.
A B C
A) End of shaft with nut
B) Washer
C) Elbow (if needed)
ENGLISH
11