Olympus D-560 Zoom - Manual (Page 13)

12
1
Names of parts
G
ett
in
g st
ar
te
d
   Memory gauge
The memory gauge lights up when you take a picture or record a movie. While
the gauge is lit, the camera is storing the picture or the movie on the card. The
memory gauge indication changes as shown below depending on the
shooting status.
If the memory gauge is fully lit, wait a few seconds until it goes off to take the
next shot.
When taking still pictures
When recording movies
   Battery check
If the remaining battery power is low, the battery check indication on the
monitor changes as follows while the camera is turned on.
Before
shooting
(Gauge is off)
No more pictures can be
taken (Fully lit)
Wait until the gauge returns
to the status on the left to
take the next shot.
One picture
taken
(Lit)
More than two
taken
(Lit)
Shoot Shoot Shoot
Wait
Before shooting
(Gauge is off)
Shoot
Wait
If you continue shooting
During shooting (Lit)
• Shooting is not possible until the lit area goes off completely.
• Movie recording ends automatically when the memory gauge is full.
Lit (Green)
(The indicator turns
off after a while)
Remaining power
level: high.
Green lamp and orange lamp on
the right of the viewfinder blink.
Remaining power level: exhausted.
Replace with new batteries.
Blinks (Red)
Remaining power level: low.
Prepare new batteries.
No indication