Olympus Stylus 810 - Manual (Page 13)

13
En
1
Press
2Y.
2
Press
12 to select [Y ON], and press o.
3
Press the shutter button fully to take the picture.
The self-timer lamp lights for approximately 10 seconds
after the shutter button is pressed, then starts blinking.
After blinking for approximately 2 seconds, the picture
is taken.
1
Press
3#.
2
Press
12 to select the flash mode, and press o.
3
Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4
Press the shutter button completely to take the picture.
Flash working range:
W (max.): Approx. 5.2 m (17 ft.)
T (max.): Approx. 3.2 m (10.4 ft.)
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for 3 minutes in shooting mode. Press the shutter button or
zoom button to reactivate the camera.
If the camera is not operated for 15 minutes after the camera enters sleep mode,
it automatically retracts the lens and turns off. To resume operation, turn on the
power again.
If the camera has been used for a long time, the internal temperature of the
camera may raise, stopping the operation automatically. In such a case, remove
the battery from the camera and leave the camera until it becomes cool. The
camera outside temperature is also raises during operation, but it is not a trouble.
Icon Flash Mode Description
No
indication
Auto flash The flash fires automatically in low light or backlight
conditions.
!
Red-eye
reduction flash The red-eye reduction flash mode significantly reduces this
phenomenon by emitting pre-flashes before firing the
regular flash.
# Fill-in flash The flash fires regardless of the available light.
$ Flash off The flash does not fire even in low light conditions.
Self-Timer
Self-Timer Lamp
Flash Modes
Power Save Feature
d4301_basic_e.book Page 13 Friday, January 6, 2006 6:14 PM