Getting to know your camera better, Shooting tips and information, Tips before you start taking pictures – Olympus Stylus 780 User Manual

Page 50: The date and time have not been set, Ab c d

Advertising
background image

50

EN

Getting to know your camera better

Getting to know your camera better

The battery is not fully charged

• Charge the battery with the charger.

The battery is temporarily unable to function because of the cold

• Battery performance declines in low temperatures, and the charge may not be sufficient to

turn on the camera. Remove the battery and warm it by putting it in your pocket for a while.

The camera is in sleep mode

• To save battery power, the camera automatically goes into sleep mode and the monitor

turns off if there is no operation when the camera is turned on (when the lens is extended
and the monitor is on). No picture is taken even if the shutter button is fully pressed in this
mode. Operate the zoom button or other buttons to restore the camera from sleep mode
before taking a picture. If the camera is left for 15 minutes, it automatically turns off (the lens
retracts and the monitor turns off). Press o to turn the camera on.

The mode dial is set to

q or P

• This is the playback mode for displaying pictures on the monitor. Set the mode dial to a

shooting mode.

The mode dial is in the position of

g

• No pictures can be taken when the shooting guide is being displayed. Take pictures after

selecting your desired shooting effect in the shooting guide or set it to a setting other than

g in shooting mode.

The flash is charging

• Wait until the # (flash charge) mark stops blinking before taking the picture.

The memory gauge is full

• No pictures can be taken when the memory gauge is full. Wait until there is space in the

memory gauge.

The camera has been used in the same conditions from the time of purchase

• No date and time have been set for the camera at the time of purchase. Set the date and

time before using the camera.

g “Turn the camera on” (P. 5)

X Setting the date and time” (P. 33)

The battery has been pulled out of the camera

• The date and time settings will be returned to the factory default settings if the camera is left

without battery for approximately 1 day. Also, the date and time setting will be canceled
earlier than this if the battery has been in the camera for a short period of time. Before taking
important pictures, check that the date and time settings are correct.

Shooting tips and information

Tips before you start taking pictures

The camera does not turn on even when a battery is loaded

No picture is taken when the shutter button is pressed

The date and time have not been set

a

b

c

d

Before taking any
pictures
(Off)

Maximum
reached
(All lit)

After taking one
picture
(Lit)

After taking several
pictures
(Lit)

Shoot

Shoot

Shoot

Wait

d4341_e_0000_7.book Page 50 Tuesday, February 20, 2007 4:28 PM

Advertising