Olympus SP-510 UZ - Manual (Page 13)

En
13
1 Press r Y.
2 Press sr to select [ Y12 SEC] or [Y2 SEC],
and press o.
3 Press the shutter button completely to take the
picture.
Y12 SEC: The self-timer lamp lights for approximately
10 seconds, then starts blinking.
After blinking for approximately 2 seconds, the
picture is taken.
Y2 SEC: The self-timer lamp blinks for 2 seconds, then
the picture is taken.
1 Press #(Flash pop-up) to open the flash.
2 Press sr to select the flash mode, and press o.
3 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4 Press the shutter button completely to take the picture.
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for 3 minutes in shooting mode. Press the shutter button
or turn the zoom lever to reactivate the camera.
If the camera is not operated for 4 hours after the camera enters sleep mode, it
automatically retracts the lens and turns off. To resume operation, turn on the
power again.
Icon Flash Mode Description
AUTO
Auto flash The flash fires automatically in low light or backlight
condition.
!
Red-eye
reduction flash
Emits pre-flashes for red-eye reduction.
# Fill-in flash The flash fires regardless of the available light.
!#
Red-eye fill-in
flash
The flash always fires after pre-flashes for red-eye
reduction are emitted.
#SLOW Slow flash The flash fires with slow speed.
$ Flash off The flash does not fire even in low light conditions.
Self-Timer
Self-Timer Lamp
Flash Modes
Power Save Feature
4322_basic_e.book Page 13 Tuesday, July 18, 2006 9:45 PM