Olympus FE-5000 - Manual (Page 34)

34 EN
Selecting a video signal system to match your TV [VIDEO OUT]
E SETUP X VIDEO OUT
The TV video signal system varies depending on the countries and regions. Before viewing camera
images on your TV, select the video output according to your TV’s video signal type.
Submenu 2 Application
NTSC Connecting the camera to a TV in North America, Taiwan, Korea, Japan, and so on.
PAL Connecting the camera to a TV in European countries, China, and so on.
The factory default settings differ according to the region where the camera is sold.
To play back camera images on a TV
1 Connect the TV and camera.
Connect to the TV video
input jack (yellow) and
audio input jack (white).
Multi-connector
AV cable (supplied)
2 Use the camera to select the same video signal system as the one of connected TV
([NTSC]/[PAL]).
3 Turn on the TV, and change “INPUT” to “VIDEO (an input jack connected to the camera).”
For details on changing the input source of the TV, refer to the TV’s instruction manual.
4 Press the q button, and use klmn to select the image for playback.
Depending on the TV’s settings, the displayed images and information may become cropped.
Saving battery power between shots
[POWER SAVE]
E SETUP X POWER SAVE
Submenu 2 Application
OFF Cancels [POWER SAVE].
ON
When the camera is not being
used for approx. 10 seconds, the
monitor automatically turns off to
save battery power.
To resume standby mode
Press any button.
Turning off the camera sounds
[F SILENT MODE]
F SILENT MODE
Submenu 1 Application
OFF
Button operation sound/shutter
sound/warning sound/sound of
image playback of pictures are
not muted.
ON
The electronic sounds (button
operation sound, shutter sound,
warning sound) and playback
sounds are muted.
[SOUND SETTINGS] (p. 33)
book_d4390_96_en_UA.indb 34 book_d4390_96_en_UA.indb 34 2008/11/04 13:31:06 2008/11/04 13:31:06