Olympus VH-520 - Manual (Page 25)

25 EN
ISO sensitivity Sets the ISO sensitivity.
l ISO Auto The camera automatically sets the sensitivity with priority on image quality.
& to Value Set a smaller value to reduce noise in the picture, or a larger value to reduce blur.
Drive Sets the sequential shooting function.
o Single One frame is shot each time the shutter button is pressed.
j Sequential
The images are taken sequentially while holding down the shutter for up to
12 frames.
O High-Speed The camera takes up to 50 sequential shots at approximately 15 frames/sec.
Image size Sets the number of recording pixels.
6 4288×3216 Suitable for printing pictures over A3 (11×17 in.).
4 3200×2400 Suitable for printing pictures up to A3 (11×17 in.).
3 1920×1440 Suitable for printing pictures up to A4 size (8.5×11 in.).
7 640×480 Suitable for using pictures on emails.
Aspect Sets the horizontal-to-vertical ratio of images.
 4:3 Change the horizontal-to-vertical ratio to 4:3 when taking pictures.
P 16:9 Change the horizontal-to-vertical ratio to 16:9 when taking pictures.
● In certain shooting modes, some functions cannot be set. Refer to “List of settings available in each shooting
mode” (p. 49)
● The image sizes are the examples when the aspect ratio is set to [].
Registering one touch white balance Registering one touch white balance
Select [ One Touch 1] or [ One Touch 2], face the camera toward a piece of white paper or other white
object, and press the
 button.
● The camera releases the shutter and the white balance is registered. When the white balance was
previously registered, the registered data is updated.
● The registered white balance data will not be cleared by turning off the power.
● Perform this procedure under the light where the pictures will be actually taken.
● When the camera settings are changed, the white balance must be registered again.
● When the white balance cannot be registered, check that the white paper fi lls the screen, and then
perform the procedure again.