Olympus DM-901 - Manual (Page 39)

3
Pla
yback
39
EN
Playback
Skipping to the beginning of a file
Skipping to the beginning of the
next file
1 Press the
9 button while the
voice recorder is in stop mode, or
during playback.
Skipping to the beginning of the
current file
1 While the voice recorder is in stop
mode or playing back, press the
0 button.
Skipping to the beginning of the
previous file
1 Press the
0 button when
the playback position is the
beginning of the file.
• To skip to the beginning of the
previous file during playback, press the
0 button twice consecutively.
NOTE
• If an index mark or temp mark is reached
when skipping to the beginning of a file
during playback, playback starts from
the position of the mark. When skipping
to the beginning of a file while the voice
recorder is in stop mode, the mark is
ignored (☞ P.44).
• If a setting other than [File Skip]
is set for [Skip Space], playback
starts after the set amount of time
has been skipped backwards or
forwards. Playback does not skip to the
beginning of the file.
Music files
If a music file transferred to the voice recorder
is unplayable, check that its sampling rate,
bit count and bit rate values are within the
supported ranges. The sampling rate, bit
count and bit rate combinations supported
for music file playback by the voice recorder
are shown below.
File format Sampling rate
Bit count/bit
rate
WAV format
44.1 kHz,
48 kHz
16 bits
MP3 format
MPEG 1 Layer 3:
32 kHz,
44.1 kHz,
48 kHz
MPEG 2 Layer 3:
16 kHz,
22.05 kHz,
24 kHz
8 to 320 kbps
WMA format
8 kHz,
11 kHz,
16 kHz,
22 kHz,
32 kHz,
44.1 kHz,
48 kHz
5 to 320 kbps
• MP3 files with variable bit rates (bit rates
converted variably in a single file) may not
play normally.
• Linear PCM-format WAV files are the only
WAV files the voice recorder can play.
Playback of other WAV files is not supported.
• Even if the file formats is compatible for
playback on this recorder, the recorder does
not support every encoder.