Olympus E-PL1 User Manual

Page 114

Advertising
background image

114

EN

Information

11

Due to its characteristics or the angle at
which you are viewing the monitor, the spot
may not be uniform in color and brightness.
This is not a malfunction.

Lens

Do not immerse in water or splash with
water.
Do not drop or exert strong force on the lens.
Do not hold at the moving part of the lens.
Do not touch the lens surface directly.
Do not touch the contact points directly.
Do not subject to abrupt temperature
changes.
The operating temperature range is –10 °C
–40 °C (14 °F – 104 °F). Always use within
this temperature range.

Legal and Other Notices

Olympus makes no representations or
warranties regarding any damages, or
benefi t expected by using this unit lawfully,
or any request from a third person, which
are caused by the inappropriate use of this
product.
Olympus makes no representations or
warranties regarding any damages or any
benefi t expected by using this unit lawfully
which are caused by erasing picture data.

Disclaimer of Warranty

Olympus makes no representations or
warranties, either expressed or implied, by
or concerning any content of these written
materials or software, and in no event
shall be liable for any implied warranty of
merchantability or fi tness for any particular
purpose or for any consequential, incidental
or indirect damages (including but not
limited to damages for loss of business
profi ts, business interruption and loss of
business information) arising from the use
or inability to use these written materials
or software or equipment. Some countries
do not allow the exclusion or limitation
of liability for consequential or incidental
damages, so the above limitations may not
apply to you.
Olympus reserves all rights to this manual.

Warning

Unauthorized photographing or use of
copyrighted material may violate applicable
copyright laws. Olympus assumes no
responsibility for unauthorized photographing,
use or other acts that infringe upon the rights of
copyright owners.





Copyright Notice

All rights reserved. No part of these written
materials or this software may be reproduced
or used in any form or by any means, electronic
or mechanical, including photocopying and
recording or the use of any type of information
storage and retrieval system, without the prior
written permission of Olympus. No liability
is assumed with respect to the use of the
information contained in these written materials
or software, or for damages resulting from
the use of the information contained therein.
Olympus reserves the right to alter the features
and contents of this publication or software
without obligation or advance notice.

FCC Notice

Radio and Television Interference
Changes or modifi cations not expressly
approved by the manufacturer may void the
user's authority to operate this equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:

Adjust or relocate the receiving antenna.
Increase the distance between the
camera and receiver.
Connect the equipment to an outlet on
a circuit different from that to which the
receiver is connected.
Consult your dealer or an experienced
radio/TV technician for help. Only the
OLYMPUS-supplied USB cable should
be used to connect the camera to USB
enabled personal computers (PC).

Any unauthorized changes or modifi cations to
this equipment would void the user's authority
to operate it.


S0027_E.indb 114

S0027_E.indb 114

2009/12/21 14:53:24

2009/12/21 14:53:24

Advertising