Olympus 5010 - Manual (Page 46)

46 EN
Connect to the HDMI
connector on the TV.
HDMI micro
connector
HDMI cable (type D/sold separately)
STYLUS-9010/
μ-9010
STYLUS-7040/
μ-7040
STYLUS-5010/
μ-5010
HDMI micro
connector HDMI micro
connector
3 Turn on the TV, and change “INPUT” to “VIDEO (an input jack connected to the camera).”
For details on changing the input source of the TV, refer to the TV’s instruction manual.
4 Turn on the camera, and use HI to select the image for playback.
Use an HDMI cable that matches the HDMI micro connector on the camera and the HDMI connector on
the TV.
When the camera and TV are connected by both an AV cable and an HDMI cable, the HDMI cable
will take priority.
Depending on the TV’s settings, the displayed images and information may become cropped.
To operate images with the TV remote
control
1 Set [HDMI CONTROL] to [ON], and turn
off the camera.
2 Connect the camera and TV with an
HDMI cable. “Connection via HDMI cable”
(p. 45)
3 First turn on the TV, and then turn on the
camera.
Operate by following the operation guide that
is displayed on the TV.
With some TVs, operations cannot be
performed with the TV remote control even
though the operation guide is displayed on
the screen.
If operations cannot be performed with the
TV remote control, set [HDMI CONTROL] to
[OFF] and operate using the camera.
●
Saving battery power between shots
[POWER SAVE]
t (Settings 3) X POWER SAVE
Submenu 2 Application
OFF Cancels [POWER SAVE].
ON
When the camera is not being
used for approx. 10 seconds, the
monitor automatically turns off to
save battery power.
To resume standby mode
Press any button.