Olympus FE-250 - Manual (Page 50)

Getting to know
your cam
era better
50
EN
Movies
• When the [IMAGE QUALITY] is set to [SHQ], the continuously recording
length of the card other than the TypeH is up to approx. 15 seconds.
• If you use a non-Olympus card or a card used for another application, such
as a computer, the message [CARD ERROR] is displayed. To use this card
with this camera, use the [FORMAT] function to format the card.
g “MEMORY FORMAT (FORMAT) Formatting the internal memory or card”
(P. 26)
This camera uses several lamps to indicate the camera status.
Image quality Image size
Remaining recording time
Internal memory Using a 512 MB card
With
sound
Without
sound
With
sound
Without
sound
SHQ
640 × 480
(30 frames/sec.)
11 sec. 11 sec.
4 min.
42 sec.
4 min.
43 sec.
HQ
320 × 240
(30 frames/sec.)
30 sec. 30 sec.
12 min.
42 sec.
12 min.
53 sec.
Using a new card
Lamp indicators
Lamp Status
Self-timer lamp The lamp lights for approximately 10 seconds, blinks for
approximately 2 seconds, and then the picture is taken.
Card access lamp Lit (red): Shooting mode
Lit (green): Playback mode
Unlit: Power is off.
Blinking (red): A picture is being recorded, the camera is
reading a movie, or images are being downloaded (when
connected to a computer).
• Do not do any of the following while the card access lamp
is blinking. Doing so may prevent the image data from
being saved and render the internal memory or card
unusable.
• Open the battery/card compartment cover
• Remove the battery
Green lamp of the
monitor Lit: The focus and exposure are locked.
Blinking: The focus and exposure are not locked.
• Release your finger from the shutter button, re-position
the AF target mark on the subject and press the shutter
button halfway again.