Scarlett SC-1159 - Manual (Page 3)

3
ASSEMBLING
· Do not operate the oil heater without the base support fixed correctly.
· To fix the rear support base, fit it tightly against the fin, until it stays in
place (as.).
· To fix the front support base, fit it tightly against the bottom on the front
panel (as.).
· After fixing the supports, confirm that the heater is stable on the floor.
USING THE APPLIANCE
· Set the thermostat to the minimal position and power switch to the position, insert
the plug to the power supply.
THERMOSTAT
· The thermostat will automatically maintain your desired room temperature.
· Set the power switch to the position.
· Turn the thermostat control clockwise all the way round until you hear a click, this sound
indicates that the oil heater is activated, the pilot light is ON. Continue turning the thermostat
control clockwise to its highest setting.
· When the pilot light is ON, the heater is activated. This light turns ON and OFF repeatedly by
order of the thermostat.
· Turning the thermostat clockwise will always increase the set temperature; turning it
anticlockwise will decrease the set temperature. The thermostat will automatically turn the
heater on and off.
NOTE:
· The room must be sealed in good condition, if not, it will not make good result because of
the influx of heat.
· After use, turn the thermostat to the minimal position and set the power switch to the
position and unplug from power supply.
MAINTENANCE AND CARE
· The oil heater should be cleaned regularly to wipe out the dust on the surface of fins. As this
may result the radiating efficient.
· Unplug from the power supply and allow the appliance to cool down.
· Wipe out with a soft damp cloth. Do not use detergent or abrasives.
· Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty,
because of damage of the paint coat.
STORAGE
· Ensure the oil heater is completely cool.
· Roll up the power cord in the supports when the heater is not in
use.
· Store the appliance in a cool, dry place.