Pioneer HTP-072 - Manual (Page 19)

Basic setup
19
En
03 03
Chapter 3:
Basic setup
Before setting up
(Australia and New Zealand models)
This receiver allows you to adjust the system setup, using the
on-screen display (OSD) that is shown on the TV screen.
• The OSD will not appear if you have connected using the
HDMI output to your TV. Use composite connections for
system setup.
First, follow the procedure below to make sure that the OSD
screen is displayed.
1 Switch on the receiver and your TV.
2 Switch the TV input to the input that connects this
receiver to the TV through the corresponding composite
video cable.
For example, if you connected this receiver to the VIDEO
jacks on your TV, make sure that the VIDEO input is now
selected.
3 Press on the remote control, then press the
HOME MENU button.
The Home Menu of the OSD screen will be displayed on the
TV. If nothing appears on the screen, try to change the TV
format setting on the receiver (see below).
Changing the TV format setting
(Australia and New Zealand models)
If the OSD screen is not displayed correctly, it may be that the
TV system is set incorrectly for your country or region.
1 Switch the receiver into standby.
2 While holding down the TUNE  button, press and hold
the  STANDBY/ON button for about two seconds.
The display shows the new setting (PAL or NTSC).
Canceling the Auto Power Down
(European and U.K. models)
When this receiver is not used over a period of several hours,
it will power down automatically. The automatic power-off
timer is set to six hours under factory settings, and the timing
can be changed or the power-off function switched off
altogether. For details, see The Auto Power Down menu on
page 32.
RECEIVER
VSX-324-K-P_YXE8_VYXE8_PWXE.book 19 ページ ２０１３年３月１３日 水曜日 午前１１時３２分