Pioneer S-ES3TB User Manual

S-es3tb, Installation precautions, Placement and fine tuning

Advertising
background image

1

En

S-ES3TB

Operating Instructions

Speaker System

WHAT’S IN THE BOX

BEFORE USE

Thank you for buying this Pioneer product.

Please read through these operating instructions before

using your speaker system to optimize performance.

• The nominal impedance of this speaker system is

8 Ω. Connect the speaker system to an amplifier with

a load impedance ranging from 6 Ω to 16 Ω (a model

with “6 Ω to 16 Ω” displayed on the speaker output

terminals).

• In order to prevent damage to the speaker system

resulting from input overload, please observe the

following precautions:

-Be sure to turn the connected devices off and

remove the power cord from the wall outlet

beforehand when changing the connection or

installation method.

-Do not use excessive amplifier volume if using a

tone control to emphasize high or low frequencies.

• Do not use the speaker to output distorted sound for

long periods of time. This can result in a fire hazard.

INSTALLATION PRECAUTIONS

• Do not install these units near a stove or other

heating appliance, or put them in a place exposed to

the sun. Such locations may cause the cabinet to

change color and the speaker system to break down.

FRONT / CENTER SPEAKERS

• Do not attach the front and center speakers to the

wall or ceiling. It may fall off and cause injury.

• This speaker system is magnetically shielded.

However, depending on the installation location,

color distortion may occur if the speaker system is

installed extremely close to the screen of a television

set.

If this happens, turn off the television, then turn it on

again after 15 min to 30 min. If the problem persists,

place the speaker system away from the television

set.

• Do not install your speakers overhead on the ceiling

or wall. The grille is designed to be detachable, and

as such it may fall and cause damage or personal

injury if installed overhead.

SURROUND SPEAKERS

• The surround speakers are not magnetically shielded

and so should not be placed near a TV or monitor, as

the interaction of magnetic materials can cause

distortion of the colors on your TV screen. Magnetic

storage media (such as floppy discs and tape or video

cassettes) should also not be kept close to these

speakers.

PLACEMENT AND FINE TUNING

FRONT SPEAKERS

For best results the speakers should be separated a

distance approximately equal to the listening distance.

Angling the speakers inward towards the listener will

improve the image stability for non-central listeners.

Close proximity to a side or rear wall will enhance the

midbass performance, although too close (particularly a

corner location) and the bass may be unnaturally high

and image performance may be degraded.

Front speakers x 2

Surround speakers x 2

Speaker cords x 5

Center speaker x 1

Non-skid pads x 12

(4 pcs x 3 sheets)

Grilles (for front speaker) x 2

Operating instructions

Center

(2 m, Tie color : Black)

Front right / left

(3 m, Tie color : Blue)

Surround right / left

(10 m, Tie color : Red)

S-ES3TB_En.fm 1 ページ 2010年4月13日 火曜日 午前11時30分

Advertising
Table of contents