Pioneer X-CM42BTD-W - Manual (Page 15)

Getting started 04
15
En
English
Français
Español
Calling the wake-up timer
It can be used to re-use an existing timer setting.
1 As well as steps 1 through 3 in “Setting the
wake-up timer”.
2 Press
/ to select “TIMER ON”, then press
ENTER.
Cancelling the wake-up timer
It can be used to turn off the timer setting.
1 As well as steps 1 through 3 in “Setting the
wake-up timer”.
2 Press
/ to select “TIMER OFF”, then
press ENTER.
Using the wake-up timer
1 Press  STANDBY/ON to turn the power
off.
2 At the wake-up time, this unit will turn on
automatically and play the selected input
function.
Note
• If at the wake-up time iPod/iPhone/iPad is not connected
to this unit or a disc is not inserted, this unit will be
turned to on and not play back the track.
• If you set the timer, take one minute or more between the
start and end time.
Using the sleep timer
The sleep timer switches off the unit after a specified time so
you can fall asleep without worrying about it.
1 Press SLEEP repeatedly to select a switch off
time.
Choose between 10 min, 20 min, 30 min, 60 min, 90 min, 120
min, 150 min, 180 min or OFF. The newly set value displays for
5 seconds, and then the setting is completed.
Note
• After setting the sleep timer, pressing SLEEP will display
how much time is remaining.
• The sleep timer can be reset by pressing SLEEP while the
remaining time is displayed.
Using Headphones
Connect to the jack plug of the headphones.
When the headphones are connected, there is no sound
output from the speakers.
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
• Before plugging in or unplugging the headphone,
reduce the volume.
• Be sure your headphone has a 3.5 mm diameter plug
and impedance between 16  and 50 . The
recommended impedance is 32 .
TIMER VOLUME
PHONES AUDIO IN
X-CM32_VXE8_En.book 15 ページ ２０１４年３月１２日 水曜日 午後２時５２分