Pioneer X-SMC01BT-S - Manual (Page 31)

Additional information 11
31
En
Unable to connect to a
Bluetooth capable device, no
sound comes out at all or
sound cuts out when
connected. (X-SMC01BT)
Are there any devices nearby that
emit electromagnetic waves in the
2.4 GHz band (microwaves, wireless
LAN devices, other Bluetooth capable
devices etc.)?
If so, either move these devices away from the unit, or stop using
other devices that emit electromagnetic waves.
Is the Bluetooth capable device too
far away from the unit, or is there
something between them?
Place the Bluetooth capable device inside the same room, with no
obstacles between them, and within a range of 10 m *.
* Only a suggested range. The actual possible communication
range may change depending upon the surrounding environment.
Is the Bluetooth capable device set to
a mode that allows for Bluetooth
wireless communication?
Check the settings on the Bluetooth capable device.
Has pairing not been completed
successfully, or has either the unit or
the Bluetooth capable device erased
the previous pairing setting?
Perform the pairing operation again.
Does the device you are trying to
connect have a supported profile?
Please use a Bluetooth capable device that supports A2DP.
The panel for the electric
slide CD door has fallen off.
It can be attached as follows.
Align the line below the arrow and the bottom of the panel, then
slide downward using both hands until you hear a clicking sound.
* The panel is designed to be removable for repairs.
Note
• If the panel is not attached correctly, the panel may not
open or close properly. It may also cause irregular noise,
so make sure the panel is positioned correctly.
• Disconnect from the AC outlet before attaching the
panel.
Problem Check Remedy
Arrows