Pioneer DDJ-ERGO-K - Manual (Page 20)

20 En
! When the [SYNC (MASTER)] button is pressed, the playing speeds
and beats of the two decks are synchronized instantaneously.
3 Operate the channel faders or crossfader to mix the
sound of the two decks and switch between them.
Inputting the sound of an external
device or microphone
The sound of the external device connected to the [AUX IN] terminals
or the sound of the microphone connected to the [MIC] terminal can be
mixed.
1 Connect the external device to the [AUX IN] or [MIC]
terminal.
2 Switch the [AUX, MIC] selector switch.
— [AUX]: Selects the external device connected to the [AUX IN]
terminals.
— [MIC]: Selects the microphone connected to the [MIC] terminal.
3 Make the TRAKTOR LE 2 software’s [Preferences] >
[Input Routing] setting.
Set [Input Aux] as shown below.
— [L(Mono)]:DDJ-ERGO AUX/MIC L
— [R]:DDJ-ERGO AUX/MIC R
4 Adjust the audio level input to the [AUX IN] or [MIC]
terminals.
— Turn the [MIC VOL] control on the main unit’s rear panel: The
[MIC] terminals’ input audio level is adjusted.
— Turn the [AUX IN VOL] control on the main unit’s rear panel: The
[AUX IN] terminals’ input audio level is adjusted.
Pioneer DJ player: Set near the center position.
Portable audio player or other device with low volume: Set clock-
wise of the center position.
5 Turn this unit’s [AUX/MIC VOL] control.
Turn this unit’s [AUX/MIC VOL] control to set the volume to a suitable
level.
Quitting the system
1 Quit TRAKTOR LE 2.
2 Slide this unit’s [ON/OFF] switch to the [OFF] position.
3 Disconnect the USB cable from your computer.
4 Turn off the connected microphone and external
equipment.