Pioneer TAD-R1 - Manual (Page 8)

8
TAD Reference One Owner’s Manual
Cone-shaped
spike
Round
spike
Caution: About installation
This unit is sold with the understanding that it is to be installed by a properly trained and equipped specialist.
All matters concerning installation and mounting should be handled by specialists or by your local dealer.
Pioneer waives all responsibility for damages to this unit as the result of improper installation/mounting,
improper use, remodeling/alteration, and natural disasters.
Caution: About the placement of this unit
This product weighs 150 kg (330 lb). Make sure that you place this product upon a surface that can easily
sustain this weight. Additionally, note that when using spikes, each spike supports some 50 kg (110 lb), and as
such may cause damage to flooring underneath a carpet or other surfaces. To avoid causing such damage, be
sure to place a sufficiently large and strong cushion underneath each spike.
As a precautionary measure, be sure to not place the unit anywhere where it might fall on a sleeping individual
in the event of an earthquake.
Concerning The Placement Of This Unit
There is an aluminum plate attached to the bottom of the unit's cabinet. It can be placed normally upon a flat
surface. This unit comes with two types of spikes that you can use to adjust the unit to the shape of the floor for
best possible placement.
We recommend the following placement methods:
For flat surfaces: no spikes
Thick carpet or mat: cone-shaped spikes
Thin carpet or mat: round spikes
INSTALLATION AND PLACEMENT
TAD-R1_En.book 8 ページ ２００６年１２月４日 月曜日 午後２時４２分