Pioneer VSX-AX2AS-s - Manual (Page 69)

Using other functions 10
69
En
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
• Press SLEEP repeatedly to set the sleep time.
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again. 1
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
• Press DIMMER repeatedly to change the brightness
of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press STATUS to check the system settings.
These appear on both the OSD and the front panel
display. 2
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press STATUS again to
switch off the display.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
SLEEP
+10
SR+
ANALOG
ATT
DISC
VIDEO
SEL
DIMMER S.RETRIEVER
CLASS D.ACCESS
ENTER
AV PARAMETER CH LEVEL
Off
30 min 60 min
90 min
SLEEP
+10
SR+
ANALOG
ATT
DISC
VIDEO
SEL
DIMMER S.RETRIEVER
CLASS D.ACCESS
ENTER
AV PARAMETER CH LEVEL
2 If the Pure Direct mode is switched on, some settings above will show OFF , even though they are on.
Input source Listening mode
Signal select Surround Back Processing
Sound Retriever Video Select
MCACC Position Room 2 / REC SEL
Room 3
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
PHOTO
SBch STEREO
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
HDD
CH CH
DVD
DISP
STATUS
96kHz STEREO
Signal Select
: AUTO
SBch Processin : OFF
Retriever
: ON
Video Select : OFF
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
: SOURCE
VSX_AX4ASi.book.fm 69 ページ ２００６年４月１１日 火曜日 午後４時１９分