Bissell 3990 - Manual (Page 6)

6.
Attach vacuum hose and tools (continued)
4. Slide the extension wand and crevice tool
together into the storage clip.
5. Slide the dusting brush/upholstery tool into
the storage clip.
6. Attach the TurboBrush by snapping it onto
the top cap of the upper tank.
Power switch
The power switch is located just below the
handle on the front of the vacuum. Push the
rocker switch “ON” (I) to vacuum, and “OFF” (O)
when cleaning is complete.
Handle positions
Press the handle release pedal, located on the
lower left side of the vacuum, with your foot to
place your vacuum into one of three cleaning
positions.
1. Upright – For storage and above floor
cleaning with tools.
2. Normal Cleaning – Press handle
release pedal once. Position used
for most household floor cleaning tasks.
3. Low Cleaning – With the vacuum in
normal cleaning position, press handle
release pedal again. Use for reaching
under low furniture such as tables,
chairs or beds.
A
ssembly
6
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate but
is raised above floor. To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward.
CAUTION:
To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.
O
peration
Tip:
Before cleaning under
low furniture, check
area first for objects
that might harm the
unit or block the
vacuum hose.
CAUTION:
Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and HEPA
post-motor) are in place. Do
not operate your vacuum
without these filters.
1.
2.
3.
ug603-2312_3990_507.indd 6 ug603-2312_3990_507.indd 6 8/13/07 2:38:06 PM 8/13/07 2:38:06 PM