Pioneer FH-P4000R - Manual (Page 47)

Digital Signal Processor
En 47
10
Section
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector adjusts the volume level of sound
from each speaker to match seat positions and
the number of people in the car and lets you
recall settings at the touch of a button. The
result is a natural sound regardless of where
you are seated. Here is a list of the positions:
Button Display Indicator Position
5
FRONT Front seat
∞
ALL All seats
2
FRONT-L Front seat left
3
FRONT-R Front seat right
1 Press DSP to select the position selector.
Press DSP until POSI appears in the display.
• If the position selector has been previously set
to a listening position then the title of that previ-
ously selected listening position will be
displayed, such as
FRONT , ALL , FRONT-L or
FRONT-R .
2 Press
2/3/5/∞ to select a listening posi-
tion.
Press one of these,
2/3/5/∞, to select a listen-
ing position as listed in the table.
• To cancel the selected listening position,
press the same button again.
• When the rear output setting is subwoofer,
you cannot select
ALL . Refer to Switching the
rear output setting on page 51.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Switching the rear output setting on
page 51.
1 Press DSP to select SUB.W .
When the rear output setting is subwoofer, you
can select
SUB.W . Press DSP until SUB.W
appears in the display.
2 Press
5 to turn subwoofer output on.
SUB.W :ON appears in the display. Subwoofer
output is now on.
• You can turn off subwoofer output by pressing
∞.