Pioneer TAD-R1 User Manual
Page 2
PIONEER CORPORATION
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC.
P.O. BOX 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404
PIONEER ELECTRONICS OF CANADA, INC.
300 Allstate Parkway, Markham, Ontario L3R 0P2, Canada TEL: 1-877-283-5901, 905-479-4411
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: 03/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: (03) 9586-6300
PIONEER ELECTRONICS DE MEXICO S.A. DE C.V.
Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico,D.F. 11000 TEL: 55-9178-4270
K002_B_En
5. Take the hex wrench out of the accessory kit, and use it to remove the six bolts from
underneath the pallet that are keeping the speaker fixed to the pallet.
6. Take the speaker off the pallet.
<SRG1004-A>
Inner packaging
Protective
cover
Inner packaging
Hex wrench
Bolts
4. After removing the outer packaging, take the protective cover off of the speaker.
÷ Keep the protective cover in a safe place after installation in case of future use.
• About speaker setup
For more information about proper setup, please refer to the Owner’s Manual. The Owner’s Manual is located inside the
Accessory Kit.
This speaker set is extremely heavy (150 kg, or 330 lb). Be careful when removing it from the
pallet to prevent possible injury or damage to the speaker set.
÷ In order to protect the floor upon which you are to place the speaker,
cover the installation area with a thick mat or rug when setting up the
speakers.
÷ Use at least three people to remove the speaker from its pallet.
÷ Avoid dragging the speaker along its bottom side, as doing so can cause
damage to the speakers.
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.