Pioneer AVH-P6500DVD - Manual (Page 11)

English
Español
Deutsch
Français
Italiano
Nederlands
Installation
10
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unautho-
rized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver’s way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• Do not place the display in a position where it
will impede the driver’s visibility or affect the
operation of your vehicle’s air bags.
• The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 7)
Fig. 7
• The cords must not cover up the area shown in
the figure below. This is necessary to allow the
amplifires to radiate freely. (Fig. 8)
Fig. 8
• When mounting the hide-away unit, make sure
none of the leads are trapped between the hide-
away unit and the surrounding metalwork or fit-
tings.
• Do not mount the hide-away unit near the heater
outlet, where it would be affected by heat, or
near the doors, where rainwater might splash
onto it.
• If the hide-away unit is installed in the passenger
compartment, anchor it securely so it does not
break free while the car is moving, and cause
injury or an accident.
• If the hide-away unit is installed under a front
seat, make sure it does not obstruct seat move-
ment. Route all leads and cords carefully around
the sliding mechanism so they do not get caught
or pinched in the mechanism and cause a short
circuit.
Installing the hide-away unit
• Install the hide-away unit with
the velcro tape. (Fig. 9)
• Thoroughly wipe off the surface
before affixing the velcro tape.
• Direct installation on the carpet is
possible if the hard velcro tape will
adhere to the carpet. Do not use the
soft velcro tape in this case.
Fig. 9
Velcro tape
(hard)
Car mat or chassis
Velcro tape
(soft)
Hide-away unit
Do not close this area.
30
°