Pioneer CNDV-700HD - Manual (Page 8)

5
Touch [Yes].
The message “Password obtained from
Pioneer should be entered to update.
Have you obtained the password? Please
press “Cancel” to stop update.” appears.
To start the updating, touch [Yes].
Alternative options:
[No]
Shows “Device Number” (“Device#”) of your
navigation system.
[Cancel]
Cancel the update.
6
Enter the password for authentication that
you obtained in the “STEP 1” section,
then touch [OK].
After touching [OK], the system starts the
authentication. When the authentication is
finished properly, the message for confirma-
tion will appear.
7
Touch [Yes] to start the update.
The navigation system restarts and then the
installation begins.
When the installation of “Disc 1” is finished,
the message that “Disc 2” is required appears.
After replacing the disc, the installation pro-
ceeds. When the update of map database is
completed, the finished message appears.
8
Touch [OK] to restart the system.
After touching [OK], the installation of system
programme begins.
While this screen appears, NEVER switch the
key position from ACC or turn the power to
the navigation system, off.
After the installation is completed, the navigation
system restarts again.
After you touch [Yes] in this screen, you can-
not abort the updating until the installation of
the system programme finishes. The update
takes approximately 3 hours in total.
MAN-CNDV-700HD-EN.fm Page 8 Tuesday, April 3, 2007 10:44 AM