Pioneer DV-610AV-S User Manual
Page 56
09
56
En
Cannot play multi-channel
audio.
• Make sure that
Audio Output Mode is set to 5.1 Channel
(page 44).
• Check that the
Dolby Digital Out, DTS Out and MPEG Out
settings (page 38) are suitable for your amplifier/receiver — check
the instruction manual that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the Speaker Installation screen are
correct (page 49).
• Check the audio options available from the disc menu.
Cannot listen to
high-sampling rate audio
through the digital output.
• Make sure that
Linear PCM Out is set to Down Sample Off
(page 38).
• As a copy-protection measure, some DVDs do not output 96 kHz
audio. In this case, even if set to
Down Sample Off, the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192 kHz or
176.4 kHz digital audio.
• The player does not output digital audio at these sampling rates.
The digital output is automatically downsampled.
Cannot output 96 kHz or
88.2 kHz digital audio.
• Check that
Linear PCM Out is set to Down Sample Off
(page 38).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM
(page 38). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that
the cable is properly connected.
Audio mix does not sound
right or sounds incomplete
(for example, inaudible
dialog).
• Make sure that
Audio Output Mode is set to 2 Channel if you’ve
connected to the stereo inputs on your amplifier or TV.
The audio recorded on a
Super VCD disc is not output
properly.
• If the audio is switched to
[2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press
AUDIO to change the soundtrack.
Can’t hear effect of Virtual
Surround.
• Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the
AUDIO OUT (5.1ch) FRONT L/R analog audio outputs.
• Make sure that
Audio Output Mode is set to 2 Channel
(page 44).
• The effectiveness of Virtual Surround varies with the disc.
Problem
Remedy
DV610AV_WV_EN.book 56 ページ ２００８年５月２２日 木曜日 午後３時４３分