03 starting up the first, Time, Choosing your tv type – Pioneer DBR-TF100GB User Manual
Page 12: Scanning for channels, Starting up the first time, Starting up the first time 03, Chapter 3
Starting up the first time
03
12
Chapter 3:
Starting up the first time
1
After all connections have been made
and the DTR is connected to the mains,
press STANDBY or any number button.
A welcome message is displayed.
2
Press SELECT.
Choosing your TV type
A message box appears on the screen
instructing you to select your TV type. Press
2/3 to select Normal (4:3) or Wide (16:9),
then press SELECT.
Scanning for channels
A message box is displayed, asking you to
confirm that your aerial is connected. After
you have confirmed your aerial connection,
press SELECT. Your DTR will scan for
channels and add all new channels found.
Scanning all channels will take a couple of
minutes. After scanning is done the lowest
numbered channel is displayed.
• If no channels are found, a warning
message is displayed. Check your aerial
connection again. You can scan again by
selecting Retry with
2/3 and pressing
SELECT.
DBR-TF100GB_09_15.p65
7/22/03, 12:14 PM
12