Pioneer ANH-P9R - Manual (Page 48)

#'
(1
*
/,6+
$XGLR $GMXVWPHQWV
8VLQJ VXEZRRIHU RXWSXW
This unit is equipped with a subwoofer output which can be switched on or off. When
a subwoofer is connected to the rear output, first, switch the rear output setting to
subwoofer, then turn the subwoofer output on. For more details, see Switching the rear
output setting on page 50.
 Q r††Ã6V9DPÃhqÃI@YUÃhqÇurÃƒ r††ГTX Г‡‚Г†ryrp‡Ã‡urƈi‚‚sr Г‚ˆ‡ƒˆ‡Г
€‚qr
! Q r††ГTX Г‡‚Г‡ˆ Г‡urГ†ˆi‚‚sr Г‚ˆ‡ƒˆ‡Г‚
“SUB. W ON” appears in the display.
‡ Press TX again to turn subwoofer output off.
6qwˆ†‡vtƈi‚‚sr Ær‡‡vt†
When the subwoofer output is on, you can adjust the cut-off frequency and the output
level of the subwoofer.
 Q r††Ã6V9DPÃhqÃI@YUÃhqÇurÃƒ r††ГTX!Г‡‚Г†ryrp‡Ã‡urƈi‚‚sr Ær‡‡vtÃ
€‚qr
When the subwoofer output is on, you can select the “SW2”.
! Q r††ГГ‚ ГГ‡‚Г†ryrp‡Ã‡urÃpˆ‡‚ssÃs r„ˆrp’
Each press of  or  selects cut-off frequencies in the following order:
50 – 63 – 80 (Hz)
" Q r††ГГ‚ ГГ‡‚Ãhqwˆ†‡Ã‡urˆ‡ƒˆ‡Ãyr‰ryÂsÇurƈi‚‚sr 
Each press of  or  increases or decreases the level of the subwoofer.
‡ “+6” – “–6” is displayed as the level is increased or decreased.
I‚‡r
‡ “SW2” is not displayed when the subwoofer output is off in the subwoofer output mode
(SW1). In this case, this mode is inactive.
$GMXVWLQJ VRXUFH OHYHOV
SLA (source level adjustment) lets you adjust the volume level of each source to
prevent radical changes in volume when switching between sources.
‡ Settings are based on the FM tuner volume level, which remains unchanged.
 8‚€ƒh rÇurÃAHLjr ɂyˆ€rÃyr‰ryÐv‡uÇurÃyr‰ryÂsÇurƂˆ prГ’‚ˆГh‡Г‡‚Г
hqwˆ†‡ÃrtÃiˆvy‡vГ89Гƒyh’r 
! Q r††Ã6V9DPÃhqÇurÃƒ r††ÃI@YU
" Q r††ГTG6Г‡‚Г†ryrp‡Ã‡urÃTG6À‚qr
# Q r††ГГ‚ ГГ‡‚Ãhqwˆ†‡Ã‡urƂˆ prɂyˆ€r
Each press of  or  increases or decreases the source volume. “+4” – “–4” is
displayed as the source volume is increased or decreased.
I‚‡r†
‡ Since the FM tuner volume is the control, it is not possible to apply source level adjustments
to the FM tuner.
‡ The MW/LW tuner volume level can also be adjusted using source level adjustment.
‡ The built-in CD and the multi-CD players are both set to the same source level adjustment
volume automatically.
‡ External unit 1 and External unit 2 are set to the same volume adjustment setting
automatically.
6HWWLQJ WKH VRXQG IRFXV HTXDOL]HU
Clarifying the sound image of vocals and instruments allows the simple staging of a
natural, pleasant sound environment.
Even greater listening enjoyment will be obtained if seating positions are chosen
carefully.
‡ “FRT1” boosts the treble on the front output and the bass on the rear output.
‡ “FRT2” boosts the treble and the bass on the front output and the bass on the rear
output. (The bass boost is the same for both front and rear.)
For both “FRT1” and “FRT2” the “H” setting provides a more pronounced effect than
the “L” setting.
ÃQ r††Ã6V9DPÃhqÃI@YUÃhqÇurÃƒ r††ÃQPTD
FRT1-H (front1-high) – FRT1-L (front1-low) – FRT2-H (front2-high) – FRT2-L (front2-
low) – CUSTM (custom) – SFEQ OFF (off)
! Q r††ГГ‚ ГГ‡‚Г†ryrp‡Ã‡urÃqr†v rq†v‡v‚
Press  or  until the desired position appears in the display.
LEFT (left) – CENTER (center) – RIGHT (right)
I‚‡r
‡ If you adjust the bass or treble, “CUSTM” memorizes an “POSI” mode in which the bass and
treble are adjusted for personal preference.
MAN-ANH-P9R-GB.fm Page 48 Tuesday, June 4, 2002 1:39 PM