Pioneer X-SMC11-S - Manual (Page 32)

Additional information 11
32
En
When an iPod/iPhone/iPad is connected
Dimensions (Rear)
Unit: mm
Power is not supplied to the
USB storage device.
Is AUTH ERR displayed on the front
panel display? No power is supplied if
the power consumption is too high.
Turn the power off then back on.
Turn the power off, then disconnect and reconnect the USB storage
device.
Press INPUT to switch to the other mode, then switch again to the
USB mode.
Problem Check Remedy
Problem Remedy
Can’t operate the iPod/iPhone/iPad by the remote control. Make sure the iPod/iPhone/iPad is connected correctly (refer to
Connecting your iPod/iPhone on page 15).
Can’t operate the iPod/iPhone/iPad. Make sure the iPod/iPhone/iPad is connected correctly (refer to
Connecting your iPod/iPhone on page 15).
If the iPod/iPhone/iPad is experiencing a hangup, try resetting the
iPod/iPhone/iPad, and reconnect it to the unit.
77
218
146
9
17
520
154
Center line