Pioneer AVH-6300BT - Manual (Page 35)

Adjusting the other party
’s
listening volume
(Function of AVH-6300BT)
To maintain the good sound quality, this unit
can adjust the other party
’s listening volume.
If the volume is not loud enough for the other
party, use this function.
% Select Far-End VOL.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
1
—2—3
# This function can be performed even while
talking on the phone.
# Settings can be stored for each device.
Switching the ring tone
(Function of AVH-6300BT)
You can select whether or not to use this
unit
’s ring tone. If this function is set to on,
the ring tone for this unit will sound.
1 Connect your cellular phone to this
unit.
2 Turn ring tone on or off.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
Using the preset dial lists
(Function of AVH-6300BT)
You can easily store up to six phone numbers
as presets.
1 Display the preset screen.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
2 Touch one of preset dial keys to select
the desired phone number.
# If you want to delete a preset phone number,
touch and hold the preset dial key.
3 Make the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
4 End the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
Making a call by entering
phone number
(Function of AVH-6300BT)
Wed 28 may
1 12:45 PM
ABCDEHGHI
012345678901
01
1 2 3
4 5 6
7 8 9
* 0 #
+ C
Off
Important
Be sure to park your vehicle in a safe place and
apply the parking brake when performing this op-
eration.
1 Switch to the entering phone number
mode.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
2 Touch the number icons to input the
numbers.
# Up to 24 digits can be entered.
3 Make the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
4 End the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 22.
Note
Entering phone number mode cannot be oper-
ated unless a Bluetooth telephone is connected
to this unit.
En
35
Section
10
Detailed
instructions
Detailed instructions