Connection diagram, Before connecting the amplifier, 03 connecting the units – Pioneer GM-A6604 User Manual

Page 6

Advertising
background image

Black plate (6,1)

Connection diagram

1 Special red battery wire

RD-223 (sold separately)
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive

+ battery term-

inal.

2 Ground wire (Black)

RD-223 (sold separately)
Connect to metal body or chassis.

3 Car stereo with RCA output jacks (sold sepa-

rately)

4 External output

If only one input plug is used, do not connect
anything to RCA input jack B.

5 Connecting wire with RCA pin plugs (sold se-

parately)

6 RCA input jack A
7 RCA input jack B
8 Speaker input terminal (use a connector in-

cluded)

Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire on page 9.

9 Speaker output terminals

Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire on page 9.

a System remote control wire (sold separately)

Connect male terminal of this wire to the sys-
tem remote control terminal of the car stereo.
The female terminal can be connected to the
auto-antenna relay control terminal. If the car
stereo lacks a system remote control terminal,
connect the male terminal to the power term-
inal via the ignition switch.

b Fuse 25 A × 2 (GM-A6604) / 30 A × 1 (GM-

A4604)

c Fuse (30 A) × 2
d Grommet
e Rear side
f Front side

Note

INPUT SELECT (input select) switch must be set.
For details, see Setting the unit on page 4.

Before connecting the
amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-
pacity of the wire is limited.

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never wire the speaker negative cable directly

to ground.

! Never band together multiple speaker’s nega-

tive cables.

<5707000008290>6

En

6

Section

03

Connecting the units

Advertising
This manual is related to the following products: