Pioneer PDK-TS25 - Manual (Page 15)

15
En
English
W
W
W
W
W
T
W
T
Installation screws 2
(M8 x 30 mm: silver)
Attaching the Plasma Display
Attachment Method
1
Attaching the Plasma Display to the stand.
Fit the stand’s support columns to the bottom of the
Plasma Display as indicated by the arrows, then slowly
insert them vertically. Be extremely careful not to insert the
support columns of the stand into any part of the Plasma
Display other than the stand insertion slots. Note that doing
so might damage the Plasma Display panel or its ports or
result in the warping of the stand.
Line up the column
supports with the bottom
of the Plasma Display as
indicated in the accompa-
nying diagram.
2
Securing the Plasma Display with
Installation screws 2.
Secure them using the enclosed hexagonal wrench.
Illustration: PDP-507XD/507XA
Installation screws 2
(M8 x 30 mm: silver)
Illustration: PDP-427XD/427XA
3
Securing the Plasma Display with
Installation screws 3/4.
Attach the Plasma Display at the points marked with
“T” using the enclosed hexagonal wrench.
Installation screws 3 (M8 x 40 mm: black)
4
Attaching the speakers.(PDP-507XD/
507XA)
Refer to the operating instructions for the speaker for
the installation method.
Caution
There have been cases where unforeseen accidents
such as the equipment breaking or falling over
occurred because the stand was installed with
wrong screws.
W
W
W
W
W T
W
T
Installation screws 4 (M8 x 60 mm: silver)
PDP-507XD/507XA
PDP-427XD/427XA