Pioneer PRS-D200 - Manual (Page 9)

9
EN
G
L
IS
H
Specifications
Power source .......................................................................... 14.4 V DC (10.8 V to 15.1 V allowable)
Grounding system ........................................................................................................... Negative type
Current consumption ...................................................................... 25.8 A (at continuous power, 4 Ω)
Average current drawn* ........................................................................... 8.7 A (4 Ω for two channels)
17.6 A (4 Ω for one channel)
17.6 A (2 Ω for two channel)
Fuse ........................................................................................................................................ 30 A x 2
Dimensions ......................................................................................... 304 (W) x 56 (H) x 202 (D) mm
Weight ........................................................................................ 2.9 kg (Leads for wiring not included)
Maximum power output ................................................................ 300 W
x 2 (4 Ω) / 1200 W x 1 (4 Ω)
Continuous power output ............................... 150 W x 2 (at 14.4 V, 4 Ω, 20 Hz to 20 kHz 1.0% THD)
600 W x 1 (at 14.4 V, 4 Ω, 1 kHz 1.0% THD)
300 W x 2 (at 14.4 V, 2 Ω, 1 kHz 1.0% THD)
Load impedance ......................................................................................... 4 Ω (2 Ω to 8 Ω allowable)
(Bridge connection: 4 Ω to 8 Ω allowable)
Frequency response ........................................................................... 10 Hz to 40 kHz (+0 dB, –3 dB)
Signal-to-noise ratio ........................................................................................ 100 dB (IEC-A network)
Distortion ........................................................................................................... 0.005 % (10 W, 1 kHz)
Separation ...................................................................................................................... 70 dB (1 kHz)
Low pass filter ................................................................................ Cut off frequency: 40 Hz to 120 Hz
Cut off slope: –12 dB/oct
High pass filter ............................................................................... Cut off frequency: 40 Hz to 120 Hz
Cut off slope: –12 dB/oct
Bass boost ............................................................................................................... Frequency: 50 Hz
Level: 0, 6, 9, 12 dB
Gain control ...................................................................................................... RCA: 400 mV to 6.5 V
Speaker: 1.6 V to 26 V
Maximum input level / impedance ......................................................................... RCA: 6.5 V / 22 kΩ
Speaker: 26 V / 90 kΩ
Note:
• Specifications and the design are subject to possible modification without notice due to
improvements.
* Average current drawn
The average current drawn is nearly the maximum current drawn by this unit when an audio
signal is input. Use this value when working out total current drawn by multiple power
amplifiers.
MAN-PRS-D200-GB.fm Page 9 Monday, February 20, 2006 4:17 PM