BT Freestyle 70 - Manual (Page 17)

17
Clip the bracket onto the base unit as shown
below.
Attach the bracket and base unit
by hooking them over the screws
protruding from the wall.
Wall mounting
Your Freestyle 70 can be wall-mounted by using
the bracket provided. You can use the bracket
as a template to mark where the screws should
go into the wall.
Drill 2 holes for the screws and insert the
wall-plugs provided (if required).
Drive the screws into the wall, leaving about
4mm free on which to mount the bracket
and base unit.
Make sure that the power supply and the
telephone cables are connected to the base
unit, then fit the cables into the channels on
the bottom of the base unit.
WALL
WALL PLUG SCREW
102mm
Before you wall-mount your Freestyle 70,
check that:
• the wall can support the weight of the base
unit and handset.
• the position you choose leaves sufficient space
so that the base unit (which is larger than
the bracket) is clear of any obstruction on the
wall, such as a shelf or cupboard. Room
should be left so that the handset can be placed
on charge without touching any obstructions.
• leave enough room for the aerial to be
extended when wall mounted.
1
2
3
5
B
A
SQUEEZE
INWARD
4