Pioneer DEX-P99RS - Manual (Page 38)

Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SRC/Off and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn
MULTI-CONTROL to switch between the
functions in the following order.
Language select (language selection)
—
SP connection (speaker setting)
—Clock
(clock)
— Off clock (off clock)—FM step (FM
tuning step)
—Auto PI (auto PI seek)—
Warning tone (warning tone)
—
Face auto open (face auto open)
—AUX1
(auxiliary input 1)
—AUX2 (auxiliary input 2)—
Dimmer (dimmer) —Brightness (brightness)
—Illumination 1 (illumination select)—
Illumination 2 (custom illumination)
—
ILL line (illumination interlock)
—Digital ATT
(digital attenuation)
—Audio Reset (audio
reset)
—Mute (sound muting/attenuation)—
Door mute 1 (intelligent mute polarity setting)
—Door mute 2 (intelligent mute setting)—
Reverse mode (reverse mode)
—Ever-scroll
(ever scroll)
—BT AUDIO (Bluetooth audio)—
Pin code input (pin code input)
—
BT Version Info. (Bluetooth version informa-
tion)
Use the following instructions to operate each
particular setting.
# BT AUDIO, Pin code input and
BT Version Info. can be selected only when Blue-
tooth adapter (e.g., CD-BTB200) is connected to
this unit.
# To cancel initial settings, press B.
Selecting the display language
For your convenience, this unit equips multi-
ple language display. You can select the lan-
guage best suited to your first language.
1 Use MULTI-CONTROL to select
Language select in the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to select the lan-
guage.
Each press of
MULTI-CONTROL selects lan-
guages in the following order:
English
—Français—Italiano—Español—
Deutsch
—Nederlands—РУССКИЙ
Setting the speakers
You need to set the speakers used with this
system.
When this setting is performed correctly, this
unit reproduces high-definition sound suited
to your system.
! You cannot change the middle-range
speaker setting. (The middle-range speaker
is always on.)
! If this setting is adjusted after performing
auto-time alignment and auto-equalizing
function, perform auto-time alignment and
auto-equalizing again.
1 Use MULTI-CONTROL to select
SP connection in the initial setting menu.
Refer to Adjusting initial settings on this page.
Initial Settings
En
38
Section
04