Pioneer CNDV-800HD - Manual (Page 7)

STEP 1; Preparation require-
ment for the upgrade
Checking “Device Number”
First, check “DEVICE NUMBER” (Device Number,
Device#) of your navigation system for later pro-
cedures. To display “Device Number”, operate the
following procedures.
1
Turn your navigation system on.
2
Press the MENU button to display the
navigation menu.
Navigation menu appears.
3
Touch the key in the following order in
the navigation menu.
[Settings]
➞ [Hardware]
➞ [Service Info Screen]
4
Write down your “Device Number” onto
the supplied “MEDIA NUMBER CARD” to
avoid mistakes.
❒ Also write down “Version” information which
would be used to confirm completion of the
update.
Getting the password for authentication
For upgrade, unique password with online issu-
ance is necessary. Access the proprietary web-
site with your PC and get your password.
The following information is required on issuing
process.
— “MEDIA NUMBER” (Media Number) printed
on supplied “MEDIA NUMBER CARD”
— “DEVICE NUMBER” (Device Number) of your
navigation system
1
Prepare both “MEDIA NUMBER” (Media
Number) and “DEVICE NUMBER”
(Device Number).
2
Access on the following website to issue
your password.
For operation of issuing the password, follow
the instruction on the website.
3
Record the password that you received.
You need to input this password accurately on
the subsequent procedure. Keep your pass-
word to avoid later mistakes.
STEP 2; Upgrade procedures
This section describes the upgrade procedures
for your navigation system.
Important notice:
The update has two phases.
Phase 1; Update the database
In this phase, take notice of the followings:
— All the functions other than AM and FM
are disabled during update. You can per-
form simplified operations by using the
TRK (/) button and VOL (/) but-
ton. (We recommend changing the AV
source to AM or FM before you start the
update.)
— The update takes approximately 3 hours in
total.
— If you turn the ignition switch off (the navi-
gation system turns off) or eject the
upgrade disc, the update resumes when
the navigation system turns on or the disc
is reinserted.
Phase 2; Update the system pro-
gramme
In this phase, take notice of the followings:
— No functions are available.
— The update takes approximately 10 min-
utes.
— NEVER stop the engine of your vehicle nor
turn off the power supply to the navigation
system until the installation is completed.
Turning the power off in this phase causes
a malfunction or failure of the navigation
system.