Installation – Pioneer AVIC-HD3 User Manual
Page 24
23
Installation
Installation using the screw holes on
the side of the navigation unit
1. Remove the side brackets.
2. Fastening the navigation unit to
the factory radio-mounting
bracket.
Position the navigation unit so that its
screw holes are aligned with the screw
holes of the bracket, and tighten the
screws at 3 or 4 locations on each side.
Use either the binding screws (5
× 6 mm)
or flush surface screws (5
× 6 mm),
depending on the shape of the bracket’s
screw holes.
Note:
In some types of automobiles, discrepancy
may occur between the navigation unit and
the dashboard. If this happens, use the sup-
plied frame to fill the gap.
If the pawl gets in the
way, bend it down
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Factory radio mounting bracket
Dashboard or console
Side bracket
Screw for fixing the side bracket
(5
× 6 mm)