Vitek VT-1702 - Manual (Page 3)

TO ASSEMBLE
1. FIRST PUT THE UNIT UPSIDE DOWN;
2. LET THE "L" SHAPE SCREW SURROUNDING THE DOME OF THE RADIATING
FLANGES OF EACH END BETWEEN THE FIRST AND THE SECOND GROUPS OF THE
RADIATING FLANGES.
3. PUT TWO WHEELS AND SUPPORTING PLATE ASSEMBLIES ON THE UNIT AND
INSERT THE "U" SHAPE SCREW INTO TWO HOLES OF THE SUPPORTING PLATE.
4. INSERT THE BUTTERFLY NUTS AND SCREW THEM TIGHTLY COUNTERCLOCKWISE.
5. STAND THE HEATER.
TO USE
1. Insert the plug into the suitable wall outlet.
1) Never use the unit in place where is not even, make sure there is nothing flammable or
easy deform object within 1 meter (36 inches).
2) Insert the plug after setting the thermostat to "OFF" position and setting the power
selected switches to “OFF" position.
3) Do not cover the unit.
4) The heater is suitable for operation on an A.C. electricity supply having the same volt
age as that show on it's rating label.
2. Press two power switches to the "ON" position then turn thermostat to the "high" posi
tion, at this moment, the unit begins to work, when the temperature rises to which you
are satisfied with, slowly turn the thermostat counter clockwise until the indicating light
of the key for power choice is out, and the room temperature thus can keep constant.
If you want to raise or lower the room temperature, you can make
another regulation: Turn the thermostat clockwise to raise the temperature and coun
terclockwise to lower it., or press only one shift of power switches to "ON" position.
NOTES:
1) The pilot lamp will be on only if the temperature is below the setting value of the ther
mostat.
2) The room must be sealed in good condition, if not, it will not make good result because
of the influx of heat.
3) The outlets of the control chamber must be kept ventilate, if not, undue move of the
thermostat may occur.
3. After use, turn the power switch to the "OFF" position first, then turn the thermostat to
the "OFF" position, and pull out the power supply plug.
3 10
ENGLISH
1702.qxd 22.04.03 17:05 Page 6