Bosch GWH 2700 ES LP - Manual (Page 6)

6 720 608 542
6
Appliance details
2.3 Unpacking the heater
Before installing the unit, be certain you have the
correct heater for your type of Gas: Propane or
Natural Gas.
Identification labels are found on the
shipping box, and on the rating plate which is located on
the right side panel of the cover.
Fig. 2 Rating plate
A Serial number
B Type of gas
The box includes:
• GWH 2700 ES
• Pressure relief valve (150 psi / 200,000 Btu rating)
• Bracket for wall hanging the heater
• Exhaust vent adaptor (with 4 screws and gasket
provided)
• Combustion air inlet adaptor (with 3 screws and gas-
ket provided)
• Installation manual (manual can be downloaded at
www.boschhotwater.com)
• Product registration card
• Energy Guide label.
Please complete and return the enclosed product
registration card.
The GWH 2700 ES is not approved or designed
for:
• Manufactured (mobile) homes, boats or any mobile
installation (modular homes are acceptable for
installation)
• Use above 8000 ft A.S.L. altitude (see page 18)
• Outdoor installation without installation of Outdoor
kit (AQOK)
• Space heating purposes
• Preheated inlet water supply.
To remove front cover
B
Loosen the two Philips head screws located on
bottom rear of cover (see Fig. 3).
Fig. 3 Loosen the two screws
B
Lift front cover panel upward and remove.
Fig. 4 Removing the front cover
To remove combustion cover (service only)
B
Open the four clips and remove the combustion
cover see Fig. 5.
Fig. 5 Remove the combustion cover