Warning – Bissell 3108 User Manual
Page 5
5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
This user’s guide has been designed to help you
get the utmost satisfaction from your BISSELL Easy
Vac. You’ll find assembly and operating instructions,
safety precautions, as well as maintenance and
troubleshooting instructions. Please read this guide
thoroughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram, assembly
instructions, and part names. Locate and organize all
parts before assembly. Familiarize yourself with the parts
and where they go. Following this user’s guide will greatly
enhance your ability to get the most performance from
your BISSELL Easy Vac for many years.
Your Easy Vac comes in four, easy to assemble
components. No tools are needed.
• Detachable Handle
• Lightweight Detachable Canister
• Floor Nozzle with PowerBrush
• Crevice Tool
Refer to assembly diagram on page 4
1.
Attach upright handle to canister vacuum
Gently slide handle over square end of
canister vacuum, pushing until buttons
on canister snap into place in opening on
handle. The handle is designed to attach
and disassemble easily as you switch from
upright to canister style cleaning.
2.
Attach floor nozzle with PowerBrush
to canister vacuum
Grasp floor nozzle with one hand, while
holding canister vacuum firmly with the other.
With firm, even pressure, press floor nozzle
into round opening at end of canister vacuum.
Continue pressing gently but firmly until floor
nozzle can go no further. As with the upright
handle, the floor nozzle is designed to attach
and disassemble easily as you switch from
level floor to tool style cleaning.
3.
Attach PowerBrush cord to canister
Plug cord attached to floor nozzle into back
of canister.
4.
Attach crevice tool to tool clip
Slide narrow end of crevice tool over angled
post on the side of the canister, then press round
end of tool into semi-circular grip located just
below the quick release cord wrap.
EASY VAC assembly is now complete.
H
ow to use this guide
A
ssembly
WARNING:
Do Not plug in your vacuum
cleaner until you have
completely assembled it per
the following instructions
and are familiar with all
instructions and operating
procedures.
ug010-0136_3108-8_706.indd 5
ug010-0136_3108-8_706.indd 5
7/27/06 4:37:33 PM
7/27/06 4:37:33 PM