BT paperjet 50 - Manual (Page 39)

PaperJet 50 user guide – Edition 3 – 29.8.00
37
Connecting to a switchboard
You can store the access code required to get an
outside line so that you only have to press the
EXTERNAL button.
With some switchboards you may also need to switch
your PaperJet 50 from TONE dialling to PULSE
dialling. Check with your switchboard manager or
supplier to see if this is necessary.
To set the dialling mode and access
number
While your PaperJet 50 is in standby mode
Press the Function button until the display
shows
INSTALLATION
Display shows TEL.LINE SET-UP
Display shows PUBL. LINE (PSTN)
Press until the display shows PRIV. LINE
(PBX)
Display shows PBX DIAL: TONE
Press to switch between TONE and PULSE .
Press to confirm. Display shows
EXT. LINE: PREFIX
Press the < > buttons to display the options:
FLASH or PREFIX . If your access code is
recall choose FLASH . If your access code is a
digit(s) choose PREFIX .
Press Start to confirm your choice.
If you select PREFIX you are asked for the
code needed to get an outside line via your
switchboard (max. three digits).
Enter your code.
To confirm.
Display shows PSTN DIAL: TONE
Press to switch between TONE and PULSE
settings to suit your switchboard.
To confirm.
To return to standby.
0-9
Volume
Volume
Volume
Volume
F
Function
Start
Start
Start
Start
Start
Start
Start
Stop
PaperJet 50 User Guide 26/7/01 10:20 am Page 37