Eu declaration of conformity – Toshiba Satellite Pro U400 User Manual
Page 4
User’s Manual
iv
U400/U400D, PORTÉGÉ M800/M800D
■
Before you connect the computer to a power source, ensure that the
voltage rating of the AC adapter matches that of the available power
source. 115 V/60 Hz in most of North and South America and some Far
Eastern countries such as Taiwan. 100 V/50 Hz in eastern Japan and
100 V/60 Hz in western Japan. 230 V/50 Hz in most of Europe, the
Middle East, and the Far East.
■
If you use an extension cable with your AC adapter, ensure that the total
ampere rating of the products plugged in to the extension cable does
not exceed the ampere rating of the extension cable.
■
To remove power from the computer, turn it off, remove the battery, and
disconnect the AC adapter from the electrical outlet.
■
To help avoid the potential hazard of electric shock, do not connect or
disconnect any cables or perform maintenance or reconfiguration of this
product during and electrical storm.
■
When setting up the computer for work, place it on a level surface.
EU Declaration of Conformity
This product is labelled with the CE Mark in accordance with Radio
Equipment and Telecommunications Terminal Equipment Directive
1999/5/EC which includes the compliance to the Electromagnetic
Compatibility Directive 2004/108/EC and the Low Voltage Directive
2006/95/EC.
CE Marking is the responsibility of TOSHIBA EUROPE GmbH,
Hammfelddamm 8, 41460 Neuss, Germany, phone +49-(0)-2131-158-01.
For a copy of the related CE Declaration of Conformity please refer to
thefollowing website:
This product and the supplied accessories are designed to observe the
required EMC (Electromagnetic Compatibility) standards. However,
Toshiba cannot guarantee that this product still observes these EMC
standards if accessories or cables not manufactured/distributed by Toshiba
are connected or implemented. To avoid in general EMC problems, the
following advice should be observed:
■
Only CE marked accessories should be connected/implemented
■
Only the best shielded data cables should be connected