Toshiba Camileo H10 - Manual (Page 67)

EN 65 EN
Section 12
Troubleshooting
Troubleshooting
1.If the LCD image is not clear when shooting, how can the focus be adjusted?
Try to switch between Macro and Normal Mode in order to check the lens whether on the proper position
or not for the object(s).(Macro Mode: For object(s) in distance of 1cm-30cm, Normal Mode: For object(s)
in distance beyond 30 cm)
2.How to shoot correctly?
First properly adjust the focus, then after pressing the shutter button, the LCD shows a “funnel” marking
in the center of the screen to record the image. Firmly hold your camcorder before the “funnel” marking
disappears, then you can get a clear picture.
3.The flash is not working.
The camcorder is in Macro Mode.
The battery power is low.
4.When recording, the digital zoom does not function.
If the “Stabilization” function is activated when recording movies, the “Tele/Wide” button for digital
zooming will be disabled.
5.The files on the memory card do not display smoothly when the LCD shows the “!” or “funnel”
marking.
The “!” means the file format is not supported and the “funnel” marking indicates the file is not read
smoothly. Delete these files and the others can then be played normally. It is recommended that you first
format the memory card before using it and avoid placing files with different formats in the same folder.
6.Why is camera Flash not active when taking pictures?
Make sure that the focus range is NOT set at Macro mode, as flash is disabled in this mode. Scroll
through Camera modes and set Flash as Auto, or Flash ON; note that Flash OFF is the default pre-set
mode for normal picture -taking. In Auto mode camera flash fires ONLY when necessary (in dark setting
as example).
7.Why do some of my indoor pictures look blurry and dark?
Camcorder extends pictures exposure time under low light/ indoor condition. Keep camcorder (and
photographed subject) steady for several seconds when taking pictures. Shutter will sound when picture
has been taken.
8.How do I charge battery?
Computer will not charge battery when connected. You must use ONLY the supplied AC charger.
Camcorder must be turned OFF; blinking light confirms charging, but light is constant when charging
has been completed.