Toshiba Portege R930 - Manual (Page 135)

Disabled Disables the USB Legacy Emulation.
Internal USB 3.0 controller
Use this option to enable or disable the internal USB 3.0 controller. If
Disabled is selected, the internal USB 3.0 port(s) on the computer will
work as USB 2.0 port(s), which will save power.
Enabled Enables the internal USB 3.0 controller. (Default)
Disabled Disables the internal USB 3.0 controller.
System ON CDP Charge Mode
Enabled Rapid USB battery charge at maximum 1.5A
while PC is powered On.
Disabled Conventional USB battery charge while PC is
powered On. (Default)
When "System ON CDP Charge Mode" is enabled, your computer can
supply USB bus power (DC5V, 1.5A) to the compatible ports while the
computer is turned on.
The "System ON CDP Charge Mode" may not work with certain external
devices even if they are compliant with the USB specifications. In those
cases, use a USB port without "USB Sleep and Charge function" or disable
“System ON CDP Charge Mode”.
It is recommended that AC adaptor be connected to the computer while
using the "System ON CDP Charge Mode".
When your computer battery capacity is too low to continue, "System ON
CDP Charge Mode" may not work. In those cases, connect the AC adaptor
and reboot the computer.
Never use USB cables not supporting this feature when "System ON CDP
Charge Mode" (DC5V, 1.5A) is enabled.
Always use the USB cable that was included with your USB device.
When "System ON CDP Charge Mode" or “USB Sleep and Charge
function” is enabled, the “USB Wakeup” function will not work. In that case,
use a USB port without "USB Sleep and Charge function" or disable both
“System ON CDP Charge Mode” and “USB Sleep and Charge function”.
SATA
This feature allows you to set conditions for SATA.
eSATA
This feature allows you to enable/disable the eSATA port.
Enabled Enables the eSATA port (Default).
User's Manual 4-18