Toshiba Magnia 3310 - Manual (Page 11)

Step 2: Installing the rail to the rack
Nut bracket Plain
Washer
(M5)
Screw
(M5X12)
Figure 1-12 Screws for installation
NOTE : The right rail differs from the left rail. Do not mistake them when installing
the rail bracket.
1. Set the rail bracket between the rack angle and the nut bracket with the Side
A of the nut bracket outside. Screw them together on the right and left of the
front and rear rack angles respectively.
Fit position of rail bracket’s top and pull out the rail bracket from the rack
angle by 5.0mm and tightly screw them.
5.0mm
Fit position of rail bracket’s top.
Fit position of rail bracket’s top
Rail bracket
1U
Side A (width between the hole edge
and bracket edge is narrow)
Rack angle
Figure 1-13 Installing the rail bracket