Toshiba UL985 - Manual (Page 18)

18
SETTING UP YOUR TV
En
glis
h
o
Press OK. If your country supports Network Guide,
The Guide Type screen will appear.
Press C or c to select Broadcast Guide or
MediaGuide.
NOTE: If you select MediaGuide, it may take time to
access the Guide screen depending on active channel
numbers.
p
Press OK. If the Ant/Cable/Satellite screen appears,
press
B or b to select Antenna, Cable or Satellite
and then press OK to check ( ).
If DVB-C is not supported in your area, Cable will not
be displayed.
• When you select Antenna or Cable, follow steps 17
to 20.
• When you select Satellite, skip to step 21.
• When you select Antenna (or Cable) and Satellite,
the Satellite Settings startup screen will appear
automatically after completing the Antenna (or
Cable) scan and pressing OK.
q
Select Next and press OK. The Auto Tuning start up
screen will appear with the option to select between
DTV and ATV, DTV or ATV if available. Use
C or c to
select the appropriate mode.
r
Press
B
or
b
to highlight Start Scan, and then press
OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will indicate
the scan status.
You must allow the television to complete the
search.
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total number
of services found.
s
Press
C
or
c
to view the DTV (digital channel) or ATV
(analogue channel) lists.
T
Use
B
or
b
to move through the list to select a
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
u
Select Next and press OK. The Satellite Settings
screen will appear. From this window, you can add the
satellites that you wish to tune and configure detailed
settings for each one individually.
Select Switch Type and choose the correct switch
configuration for your satellite dish from the settings
None, ToneBurst, DiSEqC 2way, DiSEqC 4way or
Single cable.
TV Guide Selection
Broadcast Guide
Electronic Program Guide accessed by the “GUIDE” key of your
remote control:
Select “MediaGuide” if you want to use the advanced rich media
EPG provided through the network.
*Your TV must be connected to the network.
Select “Broadcast Guide” if you want to use the simple EPG
provided by our local broadcast network, if any.
Ant/Cable/Satellite
Cable
Satellite
Next
Antenna
Auto Tuning - Antenna
Progress Found
ATV Tune Waiting...
: C7 Channel
DTV Tune 3 % 2
Satellite No. Dish LNB
ASTRA 19.2˚E
Satellite Settings
1
4
3
2
1 1
Transponder: 1/85 (10729 MHz)
Dish Type: Fixed
Lower LOF: 9750
Upper LOF: 10600
Switch Type None
LNB Power On
Done